Module library

Flanger for Elektron Analog Rytm

A barber-pole flanger for the Rytm's send bus: the sweep rises or falls without end, the right side against the left.

Module version 0.1.0-experimental. Base firmware: 1.74.

About this module

FLANGER is one effect in the Modwerk base's send-effect list. Each track sends to it from its SEND page, and it returns in stereo to the mix. Two taps glide the same way through a short delay, half a cycle apart, each faded in and out, so the sweep rises or falls without end; the right side crosses the fades, so its sweep runs against the left's. SPD sets the speed and the direction, FDBK the resonance, positive or negative. It runs at 48 kHz. The DSP is Send FX's FLANGER, unchanged.

How to use it

  1. Install the module with the Modwerk base; the base carries the send bus, its pages and the effect list.
  2. On a sound track, press AMP twice to open SEND and turn A to send the track.
  3. Select the FX track and press DELAY twice to open SEND FX; hold FUNC and turn A to choose FLANGER.
  4. Turn A to E to shape it, hold FUNC and turn E for the return level LEV, and hold FUNC to read the CPU.

Controls

SPD
Speed and direction of the sweep, -64 to +63: up to 5 Hz either way, 0 stops it.
DEP
Span of the sweep, up to 10.6 ms.
TUNE
Shortest delay, 0.1 to 5.4 ms.
FDBK
Feedback, -64 to +63: negative or positive resonance, up to 86 %.
LPF
One-pole low-pass on the wet sound; 127 is open.

Compatibility notes

Test evidence

Host: the same samples as Send FX's FLANGER over 20,000 blocks of random settings. Unit: test build MB02 reported working by the author (29 Oct 2026). rytm-emu 2ac0f1f: the SEND and SEND FX pages with FLANGER (FL02).

Module source and documentation