Module library

Euclid for Elektron Octatrack

Euclidean rhythms for filters and amplitude.

Module version 0.1.4-experimental. Base firmware: 1.40C.

About this module

Euclidean rhythms drive filter cutoff or amplitude. Set the number of steps and pulses, rotate the pattern, and shape each movement with the envelope controls. Euclid automatically follows the swing amount and selected swing steps of its audio track, including changes made with SWING ALL.

How to use it

  1. Set STEPS for the pattern length and PULSE for the number of evenly distributed events.
  2. ROT rotates the rhythm and RATE sets its time grid. TYPE selects low-pass, band-pass, high-pass, notch or amplitude modulation.
  3. FREQ sets the base cutoff, DEPTH controls movement and DEC / LEN shapes each event. AMP mode relabels these controls for level and amount.
  4. Euclid automatically follows the swing amount and selected swing steps of its audio track, including changes made with SWING ALL.
  5. Select the track, enter Grid Recording with REC, then open TRACK TRIG EDIT with FUNC+BANK and select SWING. Turn LEVEL for this track or hold FUNC while turning LEVEL for all tracks; 50% is straight timing.

Controls

FREQ
Base filter cutoff or AMP level; cutoff is 30 Hz..15 kHz logarithmic
RES
Filter resonance; inert for AMP
DEPTH
Cutoff or gain modulation: negative/down, zero/static, positive/up
DECAY
Envelope decay up to eight steps / gate length; inert for random
STEPS
Euclidean cycle length 1..64 (stored as length minus one)
PULSE
Pulse count; values above STEPS are clamped to STEPS
ROT
Shift rhythm and captured values right, modulo STEPS
RATE
Division relative to the track speed; 1/16 = one track step
TYPE
Two-pole low/high/band/notch filter response, or amplitude modulation
ATK
Attack / gate edge / random slew, 0..one step
OUT
Pulse envelope, timed gate, random sample-and-hold, captured random
MIX
Dry/wet; zero is exact passthrough, 127 fully wet (the input through the pulsed filter or amp)

Compatibility notes

Test evidence

PLAY and resume reset the clock with audio interrupts masked, restore the full prior status register, and publish initialized after every clock field. Current-build hardware and chip timing are not measured. Software verification is recorded in TESTING.md.

Module source and documentation